Dry Verge Technology

Technical Article


If you need help and advice with regard to structural surveys, building surveys, engineers reports, defects reports, including things such as cracks, dampness, condensation, foundation problems, etc, home buyers reports.

Please free phone 0800 298 5424 for a friendly chat with a surveyor.

Free phone 0800 298 5424



We have recently been contacted by a homeowner who has had problems with fascia boards where these are being used as overcladding, a subject we have talked about previously in one of our articles. Whilst carrying out the work to replace the fascia and soffit boards he came across problems with the cement verge that is to the end of the roof allowing water in. Whilst this cement technique has been used for many years there are now other alternatives available.

Dry Verges are considered in the following article.

Cement verge
If you look closely you can see cracks to the left hand side that have been filled in with cement mortar. It is only a matter of time before they open up again.


This is a cement verge which has been clipped which tends to happen in high wind areas. To be sure the tiles dont lift clips also tend to be in areas where cracking can occur to the verge.
Dry verge system. Interesting lack of skill to the fascia and soffit board with the hole opening in it.
Dry verge at the ridge level
Cement verge with smaller tiles

Gaps left for the water to get in

Close up of gaps

Dry Verge


For many years we have used cement at the verge of our roofs to fill in the gap at the end of the tile. The problem with this is that cement is traditionally being used which cracks over time and allows rainwater in. The rainwater can then cause deterioration to the adjoining baton which holds the roof tiles or slates in place. A way around this is to use dry verge technology which is a plastic shoe that fits on the edge of the verge and stops the dampness getting in. The solving of this problem when we researched it further seems to lead to other problems.



Cement verges have been used for many years and was almost the introduction of cement in the War Years. A typical house may look as follows:





One brick chimney

Main Roof:

Pitched and clad with a concrete tile

Gutters and Downpipes:


Soil and Vent Pipe:



Brick in stretcher bond (assumed)

External Joinery:

Plastic fascia and soffit boards and double glazed timber windows


Stripped concrete foundations


This is a fairly common construction for a new property on good quality ground and it is typical of the majority of houses subject to local variations such as slates rather than concrete tile roofs or pantile roofs in some areas are required such as Norfolk and Suffolk. We are going to look at the verge of where the tile is.

We have used the term assumed' as we have not opened up the structure.



Executive summaries are always dangerous as they try and encapsulate relatively complex problems in a few precise and succinct words. Having said that here is our executive summary and recommendations:

Whilst dry verge technology initially sounds to be a good idea in that the cement verges are no longer exposed and subject to cracking and deterioration eventually allowing dampness in. A dry verge, or a plastic verge or shoe can resolve the problems that can occur with the deterioration of the cement however if no thought is given to the projection the rain dripping off it does or doesn't have a proper drip it can hit windowsills below and we are aware of several complaints that have occurred due to the drips hitting the windowsill below and therefore keeping the occupants awake at night. We have also equally heard of the drips all occurring in one area and causing pattern staining to the brickwork below.

A solution therefore would be to have pre-defined drip areas as we do think the advantages of having a dry verge and a clip stopping the deterioration of the cement as well as holding the tile verge in place and stopping deterioration of any batons would be well worthwhile. The dry verges do give an alternative to the traditional waterbedded verges, they too have problems.


Time Line A brief history of verges

This is where we look at how verges have progressed over the years. This is a general look, there will be specific variations subject to each area which is why you do need a Surveyor to look at your property.




Thatched roofs. No verge problems as was formed in thatch or timber. Thatch was still the most common in the 17 th century. They were banned in London after 1666, interestingly the ban was only lifted in 1994 when the new Globe Theatre was reconstructed in London.



Clay tiles were used up until the Victorian time 1860's. In both cases the verges would have been either left or a lime mortar would have been used which is self sealing.

War Years

Introduction of concrete tiles and cement mortar started to be used more and more commonly.


Dry verges appear, plastic solution?



On a building survey the Surveyor should inspect visually externally and internally. Externally to see if there is any cracking in the cement verge and internally to see if there is any dampness getting in.



The dry verges certainly reduce the risk of the batons getting damp and the cement cracking. They do in themselves seem to have a problem as they do drip onto the walls below which can be particularly annoying if you have a bedroom windowsill beneath it. We have seen several complaints where this has kept people awake at night.



It is still very early days for plastic verges. Whilst no doubt the manufacturers will have carried out tests as to how well they last in our experience this is nothing like the same as testing in use ie, when they are actually on the properties. We have noticed an increasing use of them by developers. Only time will tell whether it has been successful.

We would also comment that every property is specific to its location whether it is an exposed area or not, of course the workmanship is very specific to how that particular dry verge has been fitted.

Independent Chartered Surveyors

If you truly do want an independent expert opinion from a surveyor with regard to valuations, mortgages, mortgage companies, surveys, building surveys, structural reports, engineers reports, specific defects report, structural surveys, home buyers reports or any other property matters please contact 0800 298 5424 for a surveyor to give you a call back.


Commercial Property

If you have a commercial property, whether it is freehold or leasehold then sooner or later you may get involved with dilapidation claims. You may wish to look at our Dilapidations Website at www.DilapsHelp.com and for Disputes go to our Disputes Help site www.DisputesHelp.com


We hope you found the article of use and if you have any experiences that you feel should be added to this article that would benefit others, or you feel that some of the information that we have put is wrong then please do not hesitate to contact us (we are only human).

The contents of the website are for general information only and are not intended to be relied upon for specific or general decisions. Appropriate independent professional advice should be paid for before making such a decision.

All rights are reserved the contents of the website are not to be reproduced or transmitted in any form in whole or part without the express written permission of www.1stAssociated.co.uk